- #B43/UCODE16_MIMO.FW DOWNLOAD HOW TO#
- #B43/UCODE16_MIMO.FW DOWNLOAD INSTALL#
- #B43/UCODE16_MIMO.FW DOWNLOAD DRIVERS#
- #B43/UCODE16_MIMO.FW DOWNLOAD DRIVER#
- #B43/UCODE16_MIMO.FW DOWNLOAD DOWNLOAD#
ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x17, vendor 0x4243) ssb: Found chip with id 0x4322, rev 0x01 and package 0x0A Code: ~]$ spryte]# dmesg spryte]# modprobe -r wlįATAL: Module wl not spryte]# modprobe -r spryte]# modprobe spryte]# rfkill unblock allīash: rfkill: command not spryte]# dmesg Please follow the instructions in this post and let us know:
#B43/UCODE16_MIMO.FW DOWNLOAD DRIVERS#
There are other drivers fighting for this device, though.
#B43/UCODE16_MIMO.FW DOWNLOAD DRIVER#
I have been getting good results with the b43 driver and the b43-firmware package which must be downloaded from the repository. Nothing seems to work.Īlso tried some "air*" drivers figuring with an 'Airport" card maybe, but no luck there either. Wired the Macbook to the network and tried everything related to "cutter", then 'broadcom", then bc43. Search Synaptic for Broadcom and you should find two versions of fwcutter there. Quote from: SpryteLy on November 30, 2015, 09:18:38 PM -Well I have had some success (succeeded in creating a dual boot w/PCLOS-LXDE and then w/PCLOS-Mate) but the main drawback seems no way to get support for the WiFi (AppleAirPortBrcm4311).
#B43/UCODE16_MIMO.FW DOWNLOAD HOW TO#
I have downloaded the bcm43xx-fwcutter.1.gz but I have no idea how to load it :-[ onto PCLinuxOS-Mate (or LXDE I may go that route). Seems odd because the PCLOS-KDE from 2012 works fine. 15:18:40 (40.7 KB/s) - ‘.bz2’ saved īroadcom-wl-5.100.138/config/wlconfig_lx_sharedīroadcom-wl-5.100.138/config/wlconfig_nomimoĪ0g0bsinitvals5.fw b0g0initvals9.fw lcn1initvals25.fw lp0initvals14.fw n0bsinitvals25.fw pcm5.fw ucode14.fw ucode24_lcn.fwĪ0g0bsinitvals9.fw ht0bsinitvals26.fw lcn1initvals26.fw lp0initvals15.fw n0initvals11.fw sslpn0bsinitvals16.Well I have had some success (succeeded in creating a dual boot w/PCLOS-LXDE and then w/PCLOS-Mate) but the main drawback seems no way to get support for the WiFi (AppleAirPortBrcm4311). Setting up firmware-b43-installer (1:019-1). 160409 files and directories currently installed.)
#B43/UCODE16_MIMO.FW DOWNLOAD INSTALL#
~$ Sudo apt-get install -reinstall firmware-b43-installerĠ upgraded, 0 newly installed, 1 reinstalled, 0 to remove and 0 not upgraded.Īfter this operation, 0 B of additional disk space will be used. TX packets:4772 errors:0 dropped:0 overruns:0 carrier:0 RX packets:4772 errors:0 dropped:0 overruns:0 frame:0 TX packets:61080 errors:0 dropped:0 overruns:4 carrier:0 RX packets:74536 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Start: Rejected send message, 1 matched rules type="method_call", sender=":1.76" (uid=999 pid=7577 comm="start networking ") interface="0_6.Job" member="Start" error name="(unset)" requested_reply="0" destination="" (uid=0 pid=1 comm="/sbin/init")Įth0 Link encap:Ethernet HWaddr 00:1b:38:8d:b3:bf Stop: Rejected send message, 1 matched rules type="method_call", sender=":1.75" (uid=999 pid=7583 comm="stop networking ") interface="0_6.Job" member="Stop" error name="(unset)" requested_reply="0" destination="" (uid=0 pid=1 comm="/sbin/init") # interfaces(5) file used by ifup(8) and ifdown(8) b43: probe of ssb0:0 failed with error -524 b43-wlan ERROR: Dual-core devices are not supported Please carefully read all instructions on this website.
#B43/UCODE16_MIMO.FW DOWNLOAD DOWNLOAD#
b43-phy0 ERROR: You must go to and download the correct firmware for this driver version. b43-phy0 ERROR: Firmware file "b43-open/ucode13.fw" not found b43-phy0 ERROR: Firmware file "b43/ucode13.fw" not found b43 ssb0:0: Direct firmware load for b43-open/ucode13.fw failed with error -2 b43 ssb0:0: Direct firmware load for b43/ucode13.fw failed with error -2 b43-phy0: Found Radio: Manuf 0x17F, ID 0x2050, Revision 2, Version 0
b43-phy0: Found PHY: Analog 4, Type 2 (G), Revision 9 b43-phy0: Broadcom 4311 WLAN found (core revision 13) Insmod /lib/modules/3.18.0-13-generic/kernel/drivers/bcma/bcma.ko Sudo apt-get install firmware-b43-installer
0 kommentar(er)
